Abit TX5 Guide de l'utilisateur télécharger pdf (Page 50)

4 Getting Started

Selecting the sensors

Use Inclinometer – Enable or disable the automatic use of the inclination measurement of the built-

in dual axis compensator (inclinometer) for scan registration in TX5 SCENE software. However, the

data of this sensor is always measured and attached to each scan. If the use of the inclinometer data

is switched ON, it is automatically used to register the scans in TX5 SCENE software; if it is switched

off, the data is ignored. You can change this behavior later in the TX5 SCENE software. For more

information, refer to the Trimble TX5 SCENESoftware User Guide.

Note – To get the most reliable data from the dual axis compensator, make sure that the

scanner‘s inclination is less than 5°. For more information, see Inclinometer (Dual Axis

Compensator), page 90.

Use Compass – Enable or disable the automatic use of data from the built-in compass for scan

registration in TX5 SCENE software. The data of the compass is always measured and attached to

each scan during scanning. If this button is switched to ON the data is automatically used for scan

registration. For more information, see Compass, page 91.

Use Altimeter – Enable or disable the automatic use of altimeter data for scan registration in TX5

SCENE software. The data of the altimeter is always measured and attached to each scan during

scanning. If this button is switched to ON the data is automatically used for scan registration. You

may want to enter a reference height before starting your scan project. This reference height then

acts as basis for all measurements made by the altimeter. Altimeter settings are in Manage /

Sensors / Altimeter. For more information, see Altimeter, page 92.

Click the Recommended Settings button to enable the use of all sensors.

Trimble TX5 3D Laser Scanner User Guide 50

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 124 125

Pas de commentaire

Abit TX5 Guide de l'utilisateur Page 50