Abit TX5 Guide de l'utilisateur télécharger pdf (Page 78)

5 TX5 Controller Software

Brightness – Set the brightness of the screen.

Calibrate the display – If you experience the touch screen to be slightly misaligned, you may have to

recalibrate it. Tap this button and follow the instructions on the appearing screen. We recommend

using a stylus to calibrate the display. If the calibration of the touch screen is corrupted so that it is

unusable, you should reset the calibration of the display to its factory settings. To do this, shut

down the scanner using the Power button. Wait until the scanner has shut down, then press and

hold down the Power button for at least five seconds until the LED on the sensor side of the scanner

illuminates yellow, then release the button again. The scanner then boots up and resets the

calibration of the touch screen to its factory settings.

Change the wallpaper – Change the wallpaper of the Home screen. Tap to get a list of available

wallpapers, which are stored on the scanner. To import new wallpapers to the scanner, use the

backup option.

Date and Time

See Setting the date and time, page 43.

Language

See Setting the interface language, page 42.

Units

See Setting the unit of length and the temperature scale, page 45.

WLAN / Connecting to the scanner via WLAN

The laser scanner has an integrated WLAN antenna that allows the scanner with to remotely

connect to portable devices, like notebooks, PDAs or tablet computers. Once you have connected

Trimble TX5 3D Laser Scanner User Guide 78

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 124 125

Pas de commentaire

Abit TX5 Guide de l'utilisateur Page 78